Stationary beet cleaner and cutter type SBRS

Feeding technique

To increase milk production and yields, you can choose to add fodder beet to the ration. Fodder beet stimulates dry matter intake from roughage and the sugars from fodder beet provide a lot of energy and ensure good rumen fermentation. To make intake by cattle more efficient and palatable, cleaning and cutting the beet is a must. The SBRS is a stationary electrically powered machine that allows you to clean and very finely cut the beet. The fodder beet is loaded into the storage bunker which is available in different sizes. The rollers underneath the bunker clean the beet and transport it to the cutting unit. As an option, you can place a conveyor belt under the cutting unit to increase the unloading height.
You can choose between a storage bunker with a capacity of 3, 4 or 6 cubic metres. As the bunker is modular, the lowering for loading can be placed on the left or right side.
The spiral rollers clean the beet and feed it to the cutting unit. The final section the beet passes over the rollers through a "tunnel", here it is additionally cleaned before being cut. Sand and other dirt falls past the rollers onto the ground below the machine.
Due to the small teeth on the cutting roller and the counter comb placed short of the roller, the beets are cut very finely. The cutting device has a mechanical stone safety device; if a stone enters the cutting unit, the counter comb folds back and the stone falls out of the cutting unit.
Simple intuitive operation.
When switched on, first the cutting cabinet turns and a few seconds later the rollers so that no voltage spikes occur. When switched off, the rollers turn off first so that the cutting cabinet is emptied.
The motors are protected against overloading.

Type

 

LxWxH (mm)

 

Width cutting
roller (mm)
 

Content (L)

 

Empty weight
(kg)
 

Required
electric power
 

SBRS 7000

4400x1890x165 (2600)

520

3000

1650

400 V, 20 A

Specifications:

  • Fully electrically driven, 400 Volt
  • Delayed start and stop of the cutting roller to prevent voltage spikes.
  • Motors with overload protection
  • Capacity up to 10,000 kg/hour
  • Very fine shredding, +/- 20x20 mm
  • Standard storage hopper 3000 litres
  • 4 cleaning rollers for thorough cleaning
  • Mechanical stone protection
  • Height adjustable
  • Simple operation
  • 2-layer powder coating

Options:

  • Storage bunker 4000 or 6000 litres
  • Conveyor for lifting the beet

Specifications:

  • Fully electrically driven, 400 Volt
  • Delayed start and stop of the cutting roller to prevent voltage spikes.
  • Motors with overload protection
  • Capacity up to 10,000 kg/hour
  • Very fine shredding, +/- 20x20 mm
  • Standard storage hopper 3000 litres
  • 4 cleaning rollers for thorough cleaning
  • Mechanical stone protection
  • Height adjustable
  • Simple operation
  • 2-layer powder coating

Options:

  • Storage bunker 4000 or 6000 litres
  • Conveyor for lifting the beet